Figure 7-6 Removing The Top Panel; Figure 7-7 Replacing The Popouts In The Top Panel - Sun Microsystems SPARCserver 1000 Service Manual

c. Lift the top panel straight up and clear of the chassis. Set it aside.
Figure 7-6 Removing the Top Panel
Replace the Popouts
4. Replace the popouts in the top panel to avoid their separation and loss:
a. Orient the popout so the dots are nearest each other (see Figure 7-7).
b. Slide the popout in until it is centered in the hole.
c. Press down on the side opposite the dot to secure the popout in place.
d. Install the remaining three popouts in the same manner.
Figure 7-7 Replacing the Popouts in the Top Panel
Internal Access
7
7-7