Auto Control Panel: System Settings - Kemppi X5 FastMig Series Operating Manual

3.3.7 Auto control panel: System settings

Changing settings
1. Turn the right control knob to highlight the desired settings parameter.
2. Press the right control knob to select the settings parameter for adjustment.
3. Turn the right control knob to select the settings value.
>> Depending on the settings parameter to be adjusted, refer also to the Settings table below for more details.
4. Confirm the new value / selection and close the adjustment view by pressing the right control knob.
Users
The system settings can be customized for up to 10 different users. In addition to the system settings, the memory
channels are user-specific. Each user can have up to 100 MIG channels, 10 TIG channels, 10 MMA channels and 10 gou-
ging channels. The memory channel and system settings are saved automatically for the logged-in user.
Settings
Parameter
User
Operation mode
Remote control
Remote mode
© Kemppi
Parameter value
Current user
MIG/TIG/MMA/Gouging
OFF/Remote/Gun
Default = OFF
Wire feed speed / Channel
78
Operating manual - EN
Description
There is always a logged-in user in the sys-
tem. When a new user logs in, the previous
user is automatically logged out.
If remote controller is not connected, this
selection is not available.
This determines what is changed with the
remote, parameter or memory channel
(available channels: 0...4). If remote con-
troller is not connected and remote not
selected, this selection is not available.
X5 FastMig
1920960 / 2039