Command Fb; Command Fo - Thies CLIMA First Class Advanced X Instructions For Use Manual

11.2.5 Command FB

<id>FB<parameter><CR>
Access:
Description:
Parameter type:
Parameter:
Type return value:
Return value:
Value range:
Initial value:

11.2.6 Command FO

<id>FO<parameter><CR>
Access:
Description:
Parameter type:
Parameter:
Type return value:
Return value:
Value range:
Initial value:
© Adolf Thies GmbH & Co. KG · Hauptstraße 76 · 37083 Göttingen · Germany
Phone +49 551 79001-0 · Fax +49 551 79001-65 · info@thiesclima.com · www.thiesclima.com
Quick start mode
reading / writing
The command selects the quick start mode or the set mode is
queried.
unsigned integer
0: Quick start mode off
1: Quick start mode on
unsigned integer
see parameter
0...1
1
Frequency output
reading / writing
The command enables or disables the frequency output. When
no parameter is entered, the set value is queried.
unsigned integer
0: deactivate frequency output
1: Output of measured frequency. The pulses from the internal
processor are acquired and re-output. The delivered frequency
is identical with the setting 7, with the difference that the pulse-
interval-ratio and the Jitter of the single current pulse are opti-
mized.
2: Output of the wind velocity by using the standard characteris-
tic curve (f = WV* 10)
a
Example: WV=10,1m/s fout=101Hz
3: Output of the wind velocity by using the latest calibration ta-
ble (f = WG* 10)
a
Example: WV=10,1m/s fout=101Hz
4: Output of the wind velocity by using the current calibration
table compensated concerning air pressure (f
Example: WV=10,1m/s fout=101Hz
5: reserved
6: reserved
7: Direct output of the measured pulse signals without applica-
tion of the calibration table or correction. In this mode the pulse
output behaves identically to 4.3351.X0.000
unsigned integer
see parameter
0...7
4
= f * 10)
a mess
021814/03/21
Page 38 of 86