Actuator Operation From Remote - AUMA SAEx 07.2 Manual

SAEx 07.2 SAEx 16.2 / SAREx 07.2
AUMA MATIC AMExC 01.1
Information
6.2.2.

Actuator operation from remote

SAREx 16.2
Figure 29: Local controls
[1] Push button for operation command in direction OPEN
[2] Push button Stop
[3] Push button for operation command in direction CLOSE
[4] Selector switch
Hot surfaces, e.g. possibly caused by high ambient temperatures or strong
direct sunlight!
Danger of burns
Check surface temperature and wear protective gloves if required.
Set selector switch [4] to position Local control (LOCAL).
The actuator can now be operated using the push buttons [1
-
Run actuator in direction OPEN: Press push button [1]
- Stop actuator: Press push button [2] Stop.
-
Run actuator in direction CLOSE: Press push button [3]
The OPEN - CLOSE operation commands can be given either in push-to-run operation
mode or in self-retaining mode. Refer to <Push-to-run operation or self-retaining:
set>. In self-retaining mode, the actuator runs to the defined end position after
pressing the button, unless another command has been received beforehand.
To operate the actuator via remote control, via commands (OPEN, STOP,
CLOSE): Set selector switch to position Remote control (REMOTE).
Operation
3]:
.
.
33