Terminal Compartment: Close - AUMA SAEx 07.2 Manual

SAEx 07.2 SAEx 16.2 / SAREx 07.2
AUMA MATIC AMExC 01.1
Information
5.2.3.

Terminal compartment: close

SAREx 16.2
Some actuators are equipped with an additional motor heater. The motor heater
minimizes condensation in the motor.
Figure 19: Terminal compartment: close
[1] Cover
[2] Screws for cover
[3] O-ring
[4] Screws for socket carrier
[5] Socket carrier
[6] Blanking plugs
[7] Cable gland (not included in delivery)
Short-circuit due to pinching of cables!
Risk of electric shock and functional failures.
Carefully fit socket carrier to avoid pinching the cables.
1. Insert the socket carrier [5] into the cover [1] and fasten with screws [4].
2. Clean sealing faces of cover [1] and housing.
3. Check whether O-ring [3] is in good condition, replace if damaged.
4. Apply a thin film of non-acidic grease (e.g. petroleum jelly) to the O-ring and
insert it correctly.
Flameproof enclosure, danger of explosion!
Risk of death or serious injury.
Handle cover and housing parts with care.
Joint surfaces must not be damaged or soiled in any way.
Do not jam cover during fitting.
5. Fit cover [1] and fasten screws [2] evenly crosswise.
6. Fasten cable glands and blanking plugs applying the specified torque to ensure
the required enclosure protection.
Electrical connection
25