Actuator Operation From Remote - AUMA SQ 14.2 Operation Instructions Manual

Operation
Information
6.2.2.

Actuator operation from remote

24
Figure 19: Local controls
[1] Push button for operation command in direction OPEN
[2] Push button Stop
[3] Push button for operation command in direction CLOSE
[4] Selector switch
Hot surfaces, e.g. possibly caused by high ambient temperatures or strong
direct sunlight!
Danger of burns
Check surface temperature and wear protective gloves, if required.
Set selector switch [4] to position Local control (LOCAL).
The actuator can now be operated using the push buttons [1 – 3]:
-
Run actuator in direction OPEN: Press push button [1]
- Stop actuator: Press push button [2] Stop.
-
Run actuator in direction CLOSE: Press push button [3]
The OPEN - CLOSE operation commands can be given either in push-to-run operation
mode or in self-retaining mode. In self-retaining mode, the actuator r
end position after pressing the button, unless another command has been received
beforehand.
Set selector switch to Remote control (REMOTE).
Now, it is possible to operate the actuator via remote control, via operation
commands (OPEN, STOP, CLOSE) or analog setpoints (e.g. 0 – 20 mA).
SQ 05.2 – SQ 14.2/SQR 05.2 – SQR 14.2
.
.
AM 01.1