Assembly; Mounting Position; Handwheel Fitting; Multi-Turn Actuator: Mount To Valve/Gearbox - AUMA SAEx 07.2 Manual

SAEx 07.2 SAEx 16.2 / SAREx 07.2
AUMA MATIC AMExC 01.1
4.

Assembly

4.1.

Mounting position

4.2.

Handwheel fitting

Information
4.3.

Multi-turn actuator: mount to valve/gearbox

4.3.1.

Output drive type A

Application
Design
SAREx 16.2
The product described in this document can be operated without restriction in any
mounting position.
For transport reason, handwheels with a diameter 15.7 inches (400 mm) and larger
are supplied separately within the scope of delivery.
Figure 6: Handwheel
[1] Spacer
[2] Input shaft
[3] Handwheel
[4] Retaining ring
1. If required, fit spacer [1] onto input shaft [2].
2. Slip handwheel [3] onto input shaft.
3. Secure handwheel [3] using the retaining ring [4] supplied.
Danger of corrosion due to damage to paint finish and condensation!
Touch up damage to paint finish after work on the device.
After mounting, connect the device immediately to electrical mains to ensure
that heater minimizes condensation.
Output drive for rising, non-rotating valve stem
Capable of withstanding thrust
Output mounting flange [1] with axial bearing stem nut [2] form one unit. Torque is
transmitted to valve stem [3] via stem nut [2].
Assembly
13