8. Tools and test equipment
Below is a list of all tools and test equipment used in these service and repair instructions.
The particular tools and test equipment required are outlined in the respective chapter.
Special tools can be purchased from the manufacturer Weinmann.
8.1 General tools
•
Slotted screwdriver size 0.5 x 3 x 100;
•
Crosstip screwdriver, size 1;
•
Crosstip screwdriver, size 2;
•
Open-ended spanner SW 7
for tube connection of pressure gauge;
•
Socket wrench 7 mm
•
Open-ended spanner SW 13,
for elbow connector at O
8.2 Special tools
The following tools are available from the manufacturers Weinmann:
•
Special tool set, consisting of:
– Special locknut tool G 3/8
for unlocking the threaded connection
on the O
inlet
2
– Special spanner SW 17
for lock nut on O
2
– Special tool
for holding the control knob
– Set: hose with injector
– Special pliers
•
Set, supply test Medumat / Modules
•
Set, test set respiration and pressure reducer flow
•
Special socket spanner SW8,
for removing toggle switch for P
in MEDUMAT Basic / Basic p Basic p
•
Calibration device
inlet;
2
inlet
max
•
Open-ended spanner SW 17
for rocker valves;
•
Open-ended spanner SW 22
for special locknut tool;
•
L-handled socket wrench 10 mm
for control knob;
•
Tweezers
for sieve set;
•
Side nippers;
•
Flat nose pliers.
WM 15349
WM 22827
WM 22828
WM 22829
WM 15359
WM 22928
WM 15440
WM 15443
WM 22862
WM 22836
Tools and test equipment
51