Weinmann MEDUMAT Basic Servicing And Repair Instructions page 43

10. Basic p only:
– Insert the toggle switch
wire points to the wall of the housing
the only way to ensure the switch toggles
correctly.
– Turn the MEDUMAT round and secure the
toggle switch by tightening the nut.
11. Insert the alarm signalling device
cure it with the screws
12.
For conversion up to appliance No. 1019 (Basic)
or 1399 (Basic p):
Push the connection
13. Insert the new pneumatic block
housing.
Make sure that
– the connector
X2
side the connection
– you push the rocker and the spindle through
the corresponding holes in the housing.
– no tubes or leads are underneath the pneu-
matic block where they may be pinched.
– the grommet is positioned correctly in the
39
housing wall (the housing wall must be in
the groove).
– the pneumatic block is resting on the four
rubber buffers.
so that the
26 red
. This is
and se-
23
.
42
into the housing wall.
13
into the
24
(on the long cable) is be-
.
12
from appliance no.:
Basic 1020; Basic p 1400
11
50
from appliance no.:
Basic 1020; Basic p 1400
42 23
up to appliance no.:
Basic 1019; Basic p 1399
13 42 23
24
X2
12
39
Repair information and repair instructions
51
33
1
26
(Basic p only)
26
(Basic p only)
43