Table of Contents
Advertisement
4. Pass the ribbon cable of new control panel
through the slot in the upper part of the housing
and glue on control panel
Fit upper part of housing
1. If your MEDUMAT Basic / Basic p is not to be
updated (straight connection on pneumatic
block), you will first have to file away a semi-
circle for the pressure measurement
connection
.
13
2. Push the pressure gauge mounting
new upper housing section
3. Wet the rubber buffers
insert them.
4. Install the filter insert:
– Insert O-ring
in the corresponding
60
groove in the valve insert.
– Check that the membrane
and smooth against the valve insert
– Press the valve insert, membrane first, into
the filter holder.
After installing, make sure that the valve insert
is lying straight in the holder.
– Take the pin
in your hand. The pin has a
61
notched side and a smooth side. Press the
pin with the
smooth
small hole on the top of the filter holder until
it is flush with the holder. The pin holds the
valve insert in position.
– Push the filter cap
5. Wet the pressure gauge
of spirit and press it into the holder.
Observe the installation position so that the dis-
play remains clearly legible.
6. Push the pressure gauge tube
el screw connection
7. Place the pressure gauge tube
pressure measuring tube
ing as illustrated.
8.
For conversion up to appliance No. 1019 (Basic)
or 1399 (Basic p):
Secure the pressure measuring tube
middle spacer with a cable tie.
9. Push locking latch
11
Remember that the slanted surface needs to be
pointing towards the device base later.
42
Repair information and repair instructions
65
.
65
into the
21
.
20
with a little spirit and
38
is lying flush
59
.
57
side forwards into the
into the housing wall.
55
with a small amount
1
into the swiv-
51
as far as it will go.
33
and the
51
/
into the hous-
49
50
to the
49
into the housing wall.
up to appliance no.:
Basic 1019; Basic p 1399
11
49
Middle spacer
p
B as ic
65
O /I
61
59
57
60
55
51
33
1
Advertisement
Table of Contents
