Table of Contents
Advertisement
15. Now take the swivelling angled connector
and push it onto the connector of the pneumat-
ic block. To fit the swivelling angled connector
properly into the upper housing section, lift the
pneumatic block slightly and push it over the
outer wall of the housing.
Make sure,
– That you push the rocker and the spindle
through the corresponding holes in the
housing
– That no tubes or leads are underneath the
pneumatic block where they may be
pinched
– That the grommet is positioned correctly in
the housing wall (the housing wall must be
in the groove)
– That the pneumatic block is resting on the
four rubber buffers.
go to step
For conversion:
go to step
For replacement:
16. Where present: If you have a device that you
have converted to a swivelling angled connec-
tor, you must insert sealing plug WM 22809
with O-ring 5-1.2 WM 1145/90 into the up-
per part of the housing where the pressure sen-
sor tube was previously fitted.
17. Remove the "
" plate from the housing.
Sensor
18. Slide the suction connector
tion tube
with the spring
45
sponding connections on the pneumatic
block
as far as they will go.
24
19. Slide the pressure tube
pneumatic block as far as it will go.
20. Secure the circuit board (see „6.12 Replacing
the circuit board" on page 29, steps
).
17.
21. Slide the tube
onto the sensor
52
22. Turn the MEDUMAT Basic / Basic p round.
36
Repair information and repair instructions
.
16.
.
18.
and the ventila-
43
onto the corre-
54
into the inlet of the
48
to
11.
.
B2
43 45
+
54
52
B2
47
48
(Basic p
only)
Advertisement
Table of Contents
