Table of Contents
Advertisement
8. Tools, testing equipment and disinfectants
This section lists all the tools and test equipment mentioned in these Service and Repair Instructions.
The specific tools and test equipment required in each case are listed in the individual chapter.
8.1 Tools
•
Phillips screwdriver, size 1;
•
Phillips screwdriver, size 2;
for screws
;
83
•
Flat-head screwdriver 0.5 x 3 x 100;
•
Torque wrench, 1 - 12 Nm;
•
Tubular hexagon box spanner 8 mm,
for torque wrench;
•
Allen (internal hexagon) key, 2 mm,
for set screw
of motor mounting;
81
•
Allen (internal hexagon) key, 3 mm,
8.2 Testing equipment and fixtures
•
Multimeter,
to measure voltage, current and resistance;
•
Hand pressure gauge,
accuracy ±0.25%
e.g. type Digima premo SR
with pressure sensor
obtainable from:
Special Instruments
Henkersgasse 2; 86720 Nördlingen
Postfach 1451; 86714 Nördlingen
Tel.: +49 9081/220-61 or -62,
Fax: +49 9081/220 63;
•
SOMNOsupport WM 23975
•
ESD workplace
•
Control cable (2 m),
required for setting pressure
obtainable under No. WM 23772
from the manufacturer, Weinmann.
44
Tools, testing equipment and disinfectants
0–50 hPa
•
Cable binder pliers MK III,
set to setting 4,
obtainable from:
Hellermann Tyton GmbH
Grosser Moorweg 45
D-25436 Tornesch
Tel.: +49 4122/701-1
Fax: +49 4122/701-400
•
Knife with smooth, flat blade,
for removing fascia film.
•
Nail scissors or hole punch for marking the
service label.
•
Remote control SOMNOadjust,
for setting pressure
obtainable under No. WM 23930
from the manufacturer, Weinmann.
Note:
The pressure can also be set by means of the
control buttons on the fascia panel.
Advertisement
Table of Contents
