Testing - Toro TITAN HD Service Manual

Key/Ignition Switch (Cont.)

Testing

1. Remove the control panel from the right console.
2. Disconnect the ignition switch from the wire harness.
3. Using a digital multi-meter set to the OHM or Continuity setting, verify that continuity exists between the
terminals listed for each switch position.
4. Using a digital multi-meter set to the OHM or Continuity setting, verify that NO continuity exists between the
terminals not listed for each switch position.
Position
1. OFF
2. Run
3. Start
9-6
Table of Contents
ELECTRICAL
Circuit "Make"
None
B + R + I + A
B + R + I + S
Digital Edition - TITAN® HD Service Manual
January 2018