Toro TITAN HD Service Manual page 60

Hydraulic System Maintenance (Cont.)
Removing the Hydraulic System Filters (Cont.)
5. Carefully, clean the area around the filters.
NOTE: Do not allow dirt to enter the hydraulic system - contamination may occur.
6. Place a drain pan below the filter to catch the oil that drains when the filter and vent plugs are removed.
7. Locate and remove the vent plug on each transmission.
8. Unscrew the filter to remove it and allow the oil to drain from the drive system.
9. Repeat this procedure for both filters.
Installing the Hydraulic System Filters and Adding Oil
1. Apply a thin coat of oil on the surface of the rubber seal of each filter.
2. Turn the filter clockwise until the rubber seal contacts the filter adapter, then tighten the filter an additional ¾ to
1 full turn (Figure 32).
3. Repeat for the opposite filter.
4. Install the filter guards over each filter that you previously removed.
5. Use the three screws to secure the filter guards.
3-42
Table of Contents
MAINTENANCE
A B
C D
F
E
Figure 32
Digital Edition - TITAN® HD Service Manual
January 2018
B
3/4