Toro TITAN HD Service Manual page 120

Toro Twin Cylinder Engine
Installation (Cont.)
9. Install the clutch onto the crankshaft ensuring that the slot in the clutch aligns with the tab on the clutch anchor
(Figure 8).
10. Install the two spring washers and the clutch bolt (Figure 9).
11. Torque the clutch bolt to 55 ± 6 ft-lbs. (66-83 Nm).
12. Install the hydrostatic drive belt onto the engine pulley
page 7-11.
13. Install the mower belt
14. Connect the clutch wire.
15. Connect the choke cable
16. Connect the throttle cable
ENGINE
see "Mower Belt Replacement," chapter 8, page 8-5.
see "Choke Cable Installation," chapter 5, page 5-26.
see "Throttle Cable Installation," chapter 5, page 5-24.
Digital Edition - TITAN® HD Service Manual
January 2018
Figure 8
Figure 9
see "Hydrostatic Drive Belt Installation," chapter 7,
6-7
Table of Contents