Toro TITAN HD Service Manual page 97

Choke Control Assembly
Removal
1. Park the machine on a level surface and disengage the PTO. Stop the engine, wait for all moving parts to stop,
and remove the key. Engage the parking brake.
2. Disconnect the battery.
3. Loosen the clamp securing the choke cable to the choke plate on the engine (A) (Figure 28).
4. Remove the choke cable from the plate (B), noting the position of the cable in the plate (Figure 28).
5. Remove the control panel assembly from the right console.
6. On the bottom side of the control panel assembly, loosen the jam nut securing the choke lever in place.
Remove the nut from the choke cable.
7. Pull the choke cable assembly through the control panel and out of the machine.
CHASSIS
B
Figure 28
Digital Edition - TITAN® HD Service Manual
January 2018
A
5-25
Table of Contents