Table of Contents
Advertisement
HYDROSTATIC DRIVE SYSTEM
Hydrostatic Drive Transmission
Installation (Cont.)
3. Install the front and rear hydro mounting bolts, washers, and nuts (B) (Figure 15). Do not tighten at this time.
NOTE: The proper torque sequence, as outlined below, is critical in avoiding damage to the hydrostatic
transmission and the frame.
4. Tighten the cross shaft bolt and torque to 43 ± 5 ft-lbs. (52-65 Nm).
5. Tighten the rear hydro mounting bolt.
6. Tighten the two axle horn bolts.
7. Tighten the front hydro mounting bolt.
8. Remove the protective cap from the hydraulic oil nipple, install the hydraulic fluid hose, and move the hose
clamp into place.
9. Connect the lower brake linkage to the transmission (Figure 17).
Figure 17
7-17
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
Hide quick links:
Advertisement
Chapters
Table of Contents
