Table of Contents
Advertisement
Tracking Adjustment
1. Disengage the PTO switch.
2. Drive to an open, flat area and move the motion control levers to the neutral-lock position.
3. Move the throttle midway between the FAST and SLOW positions.
4. Move both motion control levers fully forward until they both hit the stops in the t-slot.
5. Observe which direction the machine tracks.
6. If the machine tracks to the right, insert a 3/16 in. hex wrench through the access hole in the right front cover
panel and rotate the tracking screw clockwise or counterclockwise to adjust the travel of the lever (Figure 5).
7. If the machine tracks to the left, insert a 3/16 in. hex wrench through the access hole in the left front cover
panel and rotate the tracking screw clockwise or counterclockwise to adjust the travel of the lever (Figure 5).
8. Drive the machine, check the full forward tracking.
9. Repeat the adjustment until the desired tracking is obtained.
HYDROSTATIC DRIVE SYSTEM
Right Control Lever Shown
A. Access hole on front cover panel
B. Tracking screw
Digital Edition - TITAN® HD Service Manual
January 2018
A B
Figure 5
7-7
Table of Contents
Hide quick links:
Advertisement
Chapters
Table of Contents
