Toro TITAN HD Service Manual page 154

Hydrostatic Drive Transmission
Installation
1. Lift and support the transmission, and install the two axle horn bolts, washers, and nuts as shown. Do not fully
tighten the nuts at this time (Figure 15).
2. Align the cross shaft and install the bolt through the transmission (Figure 16) into the cross shaft (A) (Figure
15). Do not tighten at this time.
7-16
Table of Contents
HYDROSTATIC DRIVE SYSTEM
C
A. Cross Shaft
B. Front and Rear Mounting Bolts
C. Axle Horn Bolts
Digital Edition - TITAN® HD Service Manual
January 2018
B
A
B
Figure 15
Figure 16
C