Toro TITAN HD Service Manual page 177

Leveling the Mower Deck
6. Measure between the outside cutting edges (blade tips) and the flat surface. If all measurements are not within
3/16 in. (5 mm), an adjustment is required and this procedure should be continued.
7. Carefully rotate the blades so that they are perpendicular to the rear of the deck (Figure 16). Ensure the front
blade tip is lower than the rear blade tip as indicated in the Block Height and Rake Table.
8. Set the anti-scalp rollers to the top position or remove completely for this procedure.
9. For 60 in. Deck Only:
-Raise the deck to the transport position.
-Slowly loosen the adjusting screw on the lift assist spring until the screw can be removed. Save the screw for
re-installation.
8-20
Table of Contents
MOWER DECK
B
A
B
C C
Figure 16
A. Blades Front to Rear
B. Blade Tip
Digital Edition - TITAN® HD Service Manual
January 2018
A
B
C
C. Measure from the Tip of the Blade to
the Flat Surface Here