Generic Measurements - EDAN Acclarix AX4 User Manual

Acclarix AX4 Diagnostic Ultrasound System User Manual Features
Figure 7-5 Moving the Measurement Result Window
Configuring Measurement Workflow:
This system provides two measurement workflows:
Workflow A: Press Set key to start and complete measurement while press Switch key to switch
the active side. It is the default measurement workflow.
Workflow B: Press Set key to start and press Complete key to complete measurement while press
Set key to switch the active side.
All the measurement steps are described in the user manual by using Workflow A. You can go to
Utilities->Set-up->System->General page to configure the measurement workflow by checking
or unchecking "Set to Enter" checkbox. See section 9.1.1 for details.

7.3.1. Generic Measurements

A default generic measurement is automatically started when Measure is invoked. Each imaging
mode supports several types of measurements, as described below. You can switch between these
types using the touch screen buttons along the bottom of the touch screen. Some generic
measurements have options for the method used to perform the measurement. When the current
generic measurement has options available, you can view and change those options through the
Tool Options touch screen buttons.
- 70 -