EDAN Acclarix AX4 User Manual page 124

Acclarix AX4 Diagnostic Ultrasound System User Manual
Wired Settings:
The following settings apply when connecting an system to a wired network via the network port
on the side of the system.
Get Local IP: Either Manually entered (Static) or DHCP. The correct setting will depend
on how your DICOM network is administrated.
Generally a Static IP is only needed if the target PACS system requires it. If it is needed,
contact your network IT manager.
IP Address, Subnet Mask, Gateway, DNS: These settings determine how the system
communicates with your network. If you chose DHCP then your network router will set
these automatically.
manager for the appropriate settings.
Wireless Settings:
Enable Wireless: This will turn the wireless radio on/off. No wireless networks are
displayed when this is disabled.
Networks: When wireless is enabled the system will search for wireless networks that are
available and display them in this list. Networks that have been previously accessed will
show up with a asterisk ("*"). If there is currently an active network it will show up with
an checkmark ('√'). If the network requires a password it shows up with a lock icon.
Each displayed network shows the strength of the wireless signal.
Refresh: Clicking on this button updates the list of displayed networks.
The following controls require that a wireless network has been selected from the network
list. Click on the name of a network to select it.
Figure 9-6 TCP/IP settings
If you chose Manually Entered IP then contact your network IT
- 117 -
If you are unsure, try DHCP first.
Utilities