Table of Contents
Advertisement
Telnet Configuration and Capabilities
About Telnet Configuration
When you first configure your DI-300 or DI-300M, it must be done
via a computer connected to the RS-232 port. However, once the
router has been initially configured, you can use telnet to
configure it remotely as shown below:
In order to configure your DI-300 or DI-300M in this way, you
must first assign it an IP Address and connect it to your network.
See the Configuring for Internet Access chapter starting on page
38 for more information on assigning an IP Address. Once this is
configured, any station on the LAN or remote network that has
TCP/IP installed can use telnet remote management. If your
DI-300M is configured for IPX routing but not IP in menu 1,
120
Telnet Configuration and Capabilities
Advertisement
Table of Contents
