Using Telnet; Telnet Configuration; Using Telnet Via Lan; Using Telnet Via Isdn - D-Link DI-308 User Manual

DI-308 ISDN Remote Router

Using Telnet

The DI-308 router can be configured and managed using Telnet. Telnet accesses the
same built-in configuration program as the RS-232 Diagnostic port console
connection. As such, all settings that can be adjusted through the console can also be
configured using Telnet.

Telnet Configuration

In order to use Telnet, the DI-308 router must first be configured using a console
connected to the RS-232 Diagnostic port. Depending on the placement of the
management station using Telnet, the initial configuration requirements for the
router are as follows:

Using Telnet via LAN

Preparing the router for management by Telnet over the LAN only requires enabling
the LAN port, enabling Telnet, and assigning the LAN port an IP address. To do
this:
1. Connect a console to the RS-232 Diagnostic port on the rear panel of the router
and run a terminal emulation program (for more information, see Connecting the
Console to the Router and Setting Up the Console sections of this manual).
2. Enable the LAN port in the Interface Configuration submenu.
3. Assign an IP address to the LAN port in the Network Configuration submenu.
4. Enable Telnet in the Advanced Functions submenu.
5. Connect the router to the LAN.
The router can now be accessed via the LAN by the included Windows-based
Configuration program, Telnet, and SNMP management applications. For more
detailed information regarding these procedures, please refer to the Connecting the
Router section of this manual. For more information about the submenus, please
refer to the "Configuration and Management"chapter of this manual.

Using Telnet via ISDN

Preparing the router for management by Telnet over ISDN lines requires more initial
configuring of the router via the console.
To do this, you must configure an ISDN port for dial-in users.
104