Table of Contents
Advertisement
10. Source: Port #—Enter the source port of the packets that
you wish to filter. The range of this field is 0 to 65535.
11. Source: Port # Comp—In this field, you can select what
comparison quantifier you wish to use to compare to the
value given in Source: Port #. There are five options for this
field:
None.
Less.
Greater.
Equal.
Not Equal.
12. TCP Estab—This field is dependent upon the IP Protocol
field. This field will be inactive (N/A) unless the value in that
field is 6 (TCP protocol). In this field you specify what type
of TCP packets will be filtered. There are two options:
Yes—filter match only established TCP connections.
No—filter match both initial and established TCP
connections.
13. More—In this field, you can determine if you want to pass
the packet through the next filter rule before an action is
taken. There are two options for this field:
Yes.
No.
If More is Yes, then Action Matched and Action Not Matched
will be N/A.
Filter Configuration
103
Advertisement
Table of Contents
