Table of Contents
Advertisement
If the filter type is GEN (generic), the following abbreviations will
be used:
If the filter type is IPX (Novell IPX), the following abbreviations
will be used:
For more information on configuring the filter rule parameters,
refer to the next section.
To configure a specific filter rule, simply select the number of the
filter rule (1-6) you wish to configure and press ENTER. This will
take you to Menu 21.1.1—TCP/IP Filter Rule (next section).
Configuring a Filter Rule
There are four types of filter rules that you can configure. Some of
the parameters will differ depending on the type of rule. When you
first enter the filter rule menu, you will be presented with Menu
21.1.1—TCP/IP Filter Rule. If you wish to configure another type
of filter rule, you need to select the appropriate type (by pressing
100
SP—Source Port number.
DA—Destination Address.
DP—Destination Port number.
Off—Offset.
Len—Length.
PT—IPX Packet Type.
SS—Source Socket.
DS—Destination Socket.
Filter Configuration
Advertisement
Table of Contents
