Table of Contents
Advertisement
3. Ether Address -Enter the MAC address of the destination
device that you wish to bridge your packets to.
4. IP Address—If available, enter the IP address of the
destination device that you wish to bridge your packets to.
5. Gateway Node—Enter the number (1-4) of the Remote
Node that is linked to this static route. When an incoming
packet's destination Ether (MAC) address matches the value
entered above, then it will trigger a call to this Remote Node.
Once you have completed filling in the menu, press ENTER at the
message 'Press ENTER to Confirm...' to save your selections, or
press ESC at any time to cancel your selections.
Bridging Configuration
95
Advertisement
Table of Contents
