Connecting Your Computer And Your Di-300 Or Di-300M; Connecting The Rs-232 Cable To The Router; Connecting An Isdn Line To The Router - D-Link DI-300 series User Manual

Connecting Your Computer and Your DI-300 or DI-300M

For the initial setup of your DI-300 or DI-300M, you must use
RS-232 and communications software.
After the router has been successfully installed, you can modify the
configuration through a remote Telnet connection. See the Telnet
Configuration and Capabilities chapter for detailed instructions on
using Telnet to configure your DI-300 or DI-300M.

Connecting the RS-232 Cable to the Router

An RS-232 cable is included in your package. To connect this
cable, connect the 9-pin end of the cable to the DCE port on the
router's back panel. Connect the other end to the RS-232 cable
connected to the serial port (COM1, COM2, or any other COM
port) of your computer.

Connecting an ISDN Line to the Router

Plug one end of your ISDN phone line into the socket on the rear
panel of the router labeled ISDN and the other end into the ISDN
wall jack.
S/T interface—This can only connect to your NT-1
(Network Termination) device.
NOTE: Do not under any circumstances connect directly to the ISDN
wall jack.
22 Installation