Table of Contents
Advertisement
DI-206 ISDN Remote Router
Using Telnet
The DI-206 router can be configured and managed using telnet. Telnet accesses the
same built-in configuration program as the RS-232 Diagnostic port console
connection. As such, all settings that can be adjusted through the console can also be
configured using Telnet.
Telnet Configuration
In order to use telnet, the DI-206 router must first be configured using a console
connected to the RS-232 Diagnostic port. Depending on the placement of the
management station using telnet, the initial configuration requirements for the router
are as follows:
Using Telnet via LAN
Preparing the router for management by telnet over the LAN only requires enabling
the LAN port, enabling telnet, and assigning the LAN port an IP address. To do this:
1. Connect a console to the RS-232 Diagnostic port on the front panel of the router
and run a terminal emulation program (for more information, see Connecting the
Console to the Router and Setting Up the Console sections of this manual).
2. Enable the LAN port in the Interface Configuration sub-menu.
3. Assign an IP address to the LAN port in the Network Configuration sub-menu.
4. Enable Telnet in the Advanced Functions submenu.
5. Connect the router to the LAN.
The router can now be accessed via the LAN by the included Windows-based
Configuration program, Telnet and SNMP management applications. For more
detailed information regarding these procedures, please refer to the Connecting the
Router section of this manual. For more information about the submenus, please
refer to the Configuration and Management section of this manual.
Using Telnet via ISDN
Preparing the router for management by telnet over ISDN lines requires more initial
configuring of the router via the console.
To do this, you must configure an ISDN port for dial-in users. Please refer to the
Interface Configuration, ISDN submenu section of this manual.
90
Advertisement
Table of Contents
