Remote Node Setup - D-Link DI-300 series User Manual

Remote Node Setup

Follow the procedures in the Remote Node Configuration chapter
starting on page 48 to fill the protocol-independent parameters in
Menu 11, Remote Node Profile. For the protocol-dependent
parameters, follow the ensuing instructions. If the DI-300M is
configured to receive an incoming call, you can configure the
default dial-in parameters in menu 13 (see the Dial-In
Configuration chapter starting on page 59).
1. Route—Make sure IPX is among the protocols in the Route
field.
2. Edit IP/IPX/Bridge—Press the space bar to change it to Yes
and press Enter to go to the network layer options menu.
1. Dial-On-Query—This field is necessary for the DI-300M on
the client side LAN. When set to Yes, any Get Service SAP
or RIP broadcasts coming from the LAN will trigger the
DI-300M to make a call to that Remote Node. If it is set to
No, the DI-300M will not make the outgoing call.
84 Novell IPX Configuration