Table of Contents
Advertisement
3. If the call is terminated immediately after a connection is
established, there may be some kind of negotiation problem.
Verify the following parameters in menu 11: My Login, My
Password, Route, IP LAN Addr. Also verify your IP address
in menu 3.2.
4. If you check the error log in menu 24.3.1, this will usually
give you some logs regarding why the call was dropped. If
there is nothing in the log, the call may have been dropped by
the remote device that you dialed in to. Make sure that the
configuration parameters between these two devices are
consistent.
Problems Connecting to a Remote User
1. First verify that you have configured the authentication
parameters in menu 13. These would be CLID Authen, Recv.
Authen, and Mutual Authen.
2. If the Remote Dial-in User is negotiating IP, verify that the IP
address is supplied correctly in menu 13. Check that either
the Remote Dial-in User is supplying a valid IP address, or
that the router is assigning a valid address from the IP pool.
3. If the Remote Dial-in User is negotiating IPX, verify that the
IPX network number is valid from the IPX pool (if it is being
used).
4. In menu 14, verify the user name and password for the
Remote Dial-in User.
142
Troubleshooting
Advertisement
Table of Contents
