a dial-in server, you need to configure the Default Dial-In Setup
to set the operational parameters for incoming call. Additionally,
you will have to create a Remote Node for the router on the
remote network (see the Remote Node Configuration chapter
starting on page 48). An example of a DI-300 or DI-300M being
used as a dial-in server is shown below:
Default Dial-In Setup
This section covers the default dial-in parameters. The
parameters in Menu 13 affect incoming calls from all Remote
Dial-in Users and Remote Nodes before authentication is
completed. Once authentication is completed, and if it matches a
Remote Node, the router will use parameters from that
particular Remote Node.
Dial-In Configuration
61