Table of Contents
Advertisement
Collecting General Setup Information
Your DI-300 or DI-300M requires the following system
information. You can obtain all the pertinent information from your
network administrator. Record this information into the worksheet
as it becomes available. This worksheet will later be referred to as
you configure your router.
System Name—This is the name given to the router for
identification purposes. This name should be no more than 8
alphanumeric characters. Spaces are not allowed, but "-" and
"_" are accepted. This name can be obtained remotely via the
SNMP management protocol and will be displayed as the
prompt when the user enters Command Interpreter Mode.
Route IP Field—For Internet access, you will need to enable
the Route IP Field. See the Configuring for Internet Access
chapter starting on page 38 for more details on configuring
your router for Internet access. To support Novell IPX, or
Bridging, enable the appropriate protocol and reference the
related chapters for detailed information.
You have now collected all of the general setup information you
need. Make sure that you have entered all the values onto the
worksheet before proceeding to the next section.
Collecting ISDN Phone Line Information
After you have successfully installed the ISDN phone line or if you
already have one installed, you need to use the ISDN line
information to complete the worksheet and configure your router.
14
Before You Begin
Advertisement
Table of Contents
