Remote Node Setup
Follow the procedure in the Remote Node Configuration chapter
starting on page 48 to fill the protocol-independent parameters
in Menu 11, Remote Node Profile. For the protocol-dependent
parameters, follow the instructions below. If you are configuring
the router to receive an incoming call, you also need to set the
default dial-in parameters in menu 13 (see the Dial-In
Configuration chapter starting on page 59).
1. Route—Make sure IP is among the protocols in the Route
field.
2. IP Address—Enter the IP address of the gateway at the
remote site (in this case, headquarters). If the remote router is
using a different IP address than the one entered here, your
DI-300 or DI-300M will drop the call.
3. Edit IP/IPX/Bridge—Press the space bar to change it to Yes
and press Enter to go to the Menu 11.3—Remote Node
Network Layer Options menu shown below:
72
TCP/IP Configuration