Page 1
Default Gateway 192.168.0.1 (All PC's) The DI-304 does not have a console port for configuration purposes, you must use your windows browser to configure the DI-304. The router has a default IP address of 192.168.0.1 www.dlink.co.uk ftp//:ftp.dlink.co.uk Page 1...
Page 2
Ensure you PC’s are setup to receive there IP address from a DHCP server. (DI-304 in this case). You will also need to check and ensure your not running any other DHCP server in network see below. Information required from the ISP.
Page 3
Fig 3. Router Ethernet Setup The router defaults to using 192.168.0.0 as the network. DHCP addresses range 192.168.0.100-200. Change these default setting if you need to. See Fig 3. above. Copyright D-Link Europe Technical Support All trademarks acknowledged Page 3...
Page 4
Setup the country code and the router’s own ISDN number as in fig 4. Fig 5. Internet Setup From the menu in fig 5 select dialling to a single ISP. Copyright D-Link Europe Technical Support All trademarks acknowledged Page 4...
Page 5
Enter your ISP details. For PPP authentication leave the PAP or CHAP setting as the router will negotiate either at connection time. In the link type, select 64k, 128k or BOD. After the OK button is selected, you can go to the diagnostics and perform a connection tests. Copyright D-Link Europe Technical Support All trademarks acknowledged Page 5...
Page 6
Fig 7. Diagnostics Select the Dial ISDN, you should see the ISP name typed in fig 6 appear in the activity, see fig 8. Copyright D-Link Europe Technical Support All trademarks acknowledged Page 6...
Page 7
Fig 8. Diagnostics Result. ~ End of Document ~ Copyright D-Link Europe Technical Support All trademarks acknowledged Page 7...