Adjust Printable Range For Each Speed Level (Function Code 46) - Brother HLL3290CDW Service Manual

1.3.14 Adjust printable range for each speed level (Function code 46)

< Function >
This function is to adjust the printing position in horizontal / vertical direction.
Position can be adjusted in 11 steps from -0.5% to 0.5% (Printing width gets smaller when the
value is negative).
< Operating Procedure >
(1) For models with touch panel
Press the [4], and then the [6] in the initial state of maintenance mode. "MAIN SIZE SET"
is displayed on the LCD.
For models without touch panel
Press the [▲] or [▼] in the initial state of maintenance mode to display
"MAINTENANCE 46" on the LCD, and press the [OK]. "MAIN SIZE SET" is displayed on
the LCD.
(2) Press the [▲] or [▼] to display "PRINT TEST PTN" on the LCD, and press the [SET] or
[OK]. "PRINTING" is displayed on the LCD, and the print adjustment test pattern (refer to
the next page) is printed on a sheet of paper.
(3) Adjust the line so that the width is 10 mm in horizontal / vertical direction. Press the [▲] or
[▼] to display desired direction on the LCD.
• Horizontal direction→ "MAIN SIZE SET"
• Vertical direction→ "SUB SIZE SET"
Press the [SET] or [OK]. "SET: 0.0 %" is displayed on the LCD.
(4) To make the print width smaller, press the [▼] to decrease the value. Press the [SET] or
[OK] after adjusting the value.
(5) After adjustment, repeat the procedure (2) to check if the adjustment was correctly done.
When you want to return to the factory shipping state, press the [▲] or [▼] to display
"RESET PARAMETER" on the LCD, and press the [SET] or [OK].
(6) Press the [X] or [Stop] to return the machine to the initial state of maintenance mode after
adjusting the value.
5-33
Confidential