(2) Disconnect the NFC flat cable from the NFC PCB, and then release the NFC flat cable
from the securing fixtures.
(3) Release each Hook to remove the Front joint cover from the Joint cover ASSY.
(4) Release the Hook to remove the NFC PCB from the Front joint cover.
(5) Remove the two Taptite bind B M4x12 screws to remove the Joint back cover from the
Joint cover ASSY.
Taptite bind B M4x12
Harness routing: Refer to
NFC PCB
Hook
Hook
Fig. 3-62
"9. Back side of Joint cover
3-78
Joint back cover
Joint cover ASSY
NFC flat cable
Front joint cover
ASSY".
Hooks
Confidential