Brother HLL3290CDW Service Manual page 226

(6) Remove the two Taptite pan (washer) B M4x12DA screws. Pull out the Fuser unit on the
Frame L side in the direction of arrow 6a and then remove it in the direction of arrow 6b.
(7) Disconnect the Heater harness of the Fuser unit from the LVPS heater harness.
Heater harness
Fuser unit
Taptite pan (washer)
B M4x12DA
Assembling Note:
• After connecting the Heater harness, pull the Connector on the Heater harness side
while holding the Connector on the LVPS heater harness side to make sure it is locked.
LVPS heater harness
6b
Fig. 3-13
3-35
OK NG
6a
<Back side>
Confidential