Adf Performance Test (Function Code 08) - Brother HLL3290CDW Service Manual

■
Transfer to the shipping state
< Function >
This function is to transfer the machine to the shipping state when used new spare Main PCB
for repair, etc. When not perform this function to the new spare Main PCB and leave, some
software will be unavailable such as MPS applications or BrAdmin tool. Also, the machine
keeps poor state of security such as risk of leaking private information. Do not forget to
perform this function after replacing the new spare Main PCB. However, this product does not
have function for place back to the pre-shipping state from the shipping state.
< Operating Procedure >
Note:
Be careful that if the special function at start up in the preceding item is a valid state
([FUNC_ENABLE]), it is unable to transfer the machine to the shipping state.
Be sure to operate after changing to an invalid state ([FUNC_DISABLE]).
(1) For models with touch panel
Press the [0], and then the [3] in the initial state of maintenance mode. "1.SWSUM?" is
displayed on the LCD.
For models without touch panel
Press the [▲] or [▼] in the initial state of maintenance mode to display
"MAINTENANCE 03" on the LCD, and press the [OK]. "1.SWSUM?" is displayed on the
LCD.
(2) Press the [▲] or [▼] to select "3.ShippingStat?" and then press the [Start] or [Mono Start].
"ON" or "OFF: Change OK?" is displayed on the LCD.
(3) When "ON" is displayed on the LCD, the machine is at shipping state. Press the [X] or
[Stop] to return to the initial state of the maintenance mode.
When "OFF: Change OK?" is displayed on the LCD, press the [SET]. The machine will
transfer to the shipping state and returns to the initial state of the maintenance mode.
1.3.3

ADF performance test (Function code 08)

< Function >
This function is used to test the performance of the automatic document feeder (ADF). The scanned
pages of the documents fed by the ADF are counted and the result is displayed on the LCD.
< Operating Procedure >
(1) Set the documents in the ADF unit. "DOC. READY" is displayed on the LCD.
(2) For models with touch panel
Press the [0], and then the [8] in the initial state of maintenance mode. "ADF CHECK P.**"
is displayed on the LCD, and the documents are ejected while the scanned pages are
counted. (** indicates the current count of the scanned pages.)
For models without touch panel
Press the [▲] or [▼] in the initial state of maintenance mode to display
"MAINTENANCE 08" on the LCD, and press the [OK]. "ADF CHECK P.**" is displayed
on the LCD, and the documents are ejected while the scanned pages are counted. (**
indicates the current count of the scanned pages.)
(3) When the [X] or [Stop] is pressed, the machine returns to the initial state of maintenance mode.
5-6
Confidential