Set Worker Switches (Wsw) And Print Worker Switch Setting Data (Function Code 10, 11) - Brother HLL3290CDW Service Manual

1.3.5 Set worker switches (WSW) and print worker switch setting data
(Function code 10, 11)
[1] Set worker switches (Function code 10)
< Function >
The worker switches shown in the table below can be used to set the function to satisfy various
requirements. These switch settings can be changed using the keys on the control panel.
The worker switches are factory set to conform to the laws and regulations of the country the
machine is shipped to. Do not change these settings unless necessary.
WSW No.
WSW01
WSW02
WSW03
WSW04
WSW05
WSW06
WSW07
WSW08
WSW09
WSW10
WSW11
WSW12
WSW13
WSW14
WSW15
WSW16
WSW17
WSW18
WSW19
WSW20
WSW21
WSW22
WSW23
WSW24
WSW25
WSW26
WSW27
WSW28
WSW29
WSW30
WSW31
WSW32
WSW33
Function
Dial pulse setting
Tone signal setting
PABX mode setting
Transfer facility setting
1st dial tone and busy tone
detection
[Redial/Pause] and 2nd dial
tone detection
Dial tone setting 1
Dial tone setting 2
Protocol definition 1
Protocol definition 2
Busy tone setting
Signal detection condition setting
Modem setting
AUTO ANS facility setting
Redial facility setting
Function setting
Function setting
Function setting
Transmission speed setting
Overseas communication mode
setting
TAD setting 1
ECM and call waiting caller ID
Communication setting
TAD setting 2
TAD setting 3
Function setting
Function setting
Function setting
Function setting
Function setting
Function setting
Function setting
Function setting
WSW No.
WSW34 Function setting
WSW35 Function setting
WSW36 Function setting
WSW37 Memory operation
WSW38 V.34 transmission settings
WSW39 V.34 transmission speed
WSW40 V.34 modem settings
WSW41 ON-duration of the scanning
light source
WSW42 Internet mail settings
WSW43 Function setting
WSW44 Speeding up scanning-1
WSW45 Function setting
WSW46 PC power monitoring and
parallel port settings
WSW47 Switching between high- and
full-speed USB
WSW48 USB setup latency
WSW49 End-of-copying beep
WSW50 SDAA setting
WSW51 Function setting
WSW52 Function setting
WSW53 Function setting
WSW54 Function setting
WSW55 Paper setting / Internal
temperature setting / Fan setting
WSW56 Function setting
WSW57 Function setting
WSW58 Function setting
WSW59 Function setting
WSW60 Function setting
WSW61 Scanning light intensity to judge
to be stable 1
WSW62 Reading motor temperature
counter / Submission confirmation
when IFAX / Scan to Email is set.
WSW63 Function setting
5-8
Function
Confidential