Fine-Tune Scanning Position (Function Code 54) - Brother HLL3290CDW Service Manual

1.3.16 Fine-tune scanning position (Function code 54)

<Function>
This function is used to adjust the scanning start/end positions.
<Operating Procedure>
(1) For models with touch panel
Press the [5], and then the [4] in the initial state of maintenance mode. "SCAN START
ADJ" is displayed for two seconds, and then "0: ADF 1: FB" is displayed on the LCD.
To adjust the ADF scanning position, press the [0] and proceed to the procedure (2). To
adjust the FB scanning position, press the [1] and proceed to the procedure (3).
For models without touch panel
Press the [▲] or [▼] in the initial state of maintenance mode to display
"MAINTENANCE 54" on the LCD, and press the [OK]. "SCAN START ADJ" is displayed
for two seconds, and then "▲: ADF ▼: FB" is displayed on the LCD.
To adjust the ADF scanning position, press the [▲] and proceed to the procedure (2). To
adjust the FB scanning position, press the [▼] and proceed to the procedure (3).
(2) "0:MAIN 1:TP 2:HP" is displayed on the LCD. Press the [0] to adjust the main scanning.
Press the [1] to adjust the vertical scanning. Press the [2] to adjust the rear end side of the
vertical scanning.
• For duplex scanning models
"0:FRONT 1:BACK" is displayed on the LCD. Press the [0] to adjust the first side. Press
the [1] to adjust the second side.
• For single-side scanning models
Proceed to the procedure (4).
(3) "0:MAIN 1:SUB" is displayed on the LCD. Press the [0] to adjust the main scanning. Press
the [1] to adjust the vertical scanning, and proceed to the procedure (4).
(4) The currently set value is displayed on the LCD. To increase the adjustment value, press the
[▲]. To decrease the adjustment value, press the [▼]. (Refer to the figure below)
Note:
When the [X] or [Stop] is pressed, the machine stops correcting the adjusting value and
returns to the initial state of maintenance mode.
(5) Press the [SET] or [OK] after adjusting the value. "Accepted" is displayed on the LCD, and
the machine returns to the initial state of maintenance mode.
Fig. 5-11
5-37
Confidential