Qiagen EZ2 Connect User Manual page 36

EZ2 Connect Tip Rack
Figure 11. EZ2 Connect Tip Rack.
The EZ2 Connect Tip Rack consists of two separate parts. The left part of the tip rack is used for
labware in positions from 1 to 12. The right part of the tip rack is used for labware in positions 13
to 24.
The EZ2 Connect Tip Racks are located at the front of the worktable. Each consists of four rows and
12 columns.
Individual positions in the EZ2 Connect Tip Rack are marked by engravings. During run setup, the
User Interface gives instruction to load specific positions of the EZ2 Connect Cartridge Rack with
filter tips in tip holders, sample tubes, enzymes in tubes, or elution tubes.
Figure 12. Tip holders and filter tips.
Important: Only use QIAGEN recommended tubes for elution.
For information on how to load the EZ2 Connect Tip Rack, refer to the section Loading the tip rack.
EZ2 Connect and EZ2 Connect Fx User Manual 09/2021 36