The software will automatically proceed to the next screen. Depending on the scanned Q-Card
barcode, the software will automatically skip selections screens if the required information is
provided by bar code scanning.
5.4.2
Selecting a kit
To select a kit that is to be used during the protocol run, tap a kit name in the Select kit pane.
Note: If there is only one available option, it is selected automatically.
Figure 53. Select kit step.
After you select a kit, the Next button is enabled. To proceed to the Select protocol step, tap Next.
To cancel the protocol, tap Cancel.
5.4.3
Selecting a protocol
To select a protocol that is compatible with the kit selected in the Select kit step, tap a protocol in
the Select protocol pane.
Note: If there is only one available option, it is selected automatically.
EZ2 Connect and EZ2 Connect Fx User Manual 09/2021
82