Mitsubishi Outlander PHEV 2019 Manual page 212

When the sensor performance returns, the
AHB will resume operation.
If the warning display does not disappear af-
ter waiting for a while, there is a possibility
that the sensor has a malfunction. Contact a
MITSUBISHI MOTORS Authorized Service
Point for inspection of the sensor.
Welcome light
E00528902072
This function turns on the position and tail
lamps for about 30 seconds after the UN-
LOCK switch on the remote control transmit-
ter is pressed when the combination head-
lamps and dipper switch is in the "OFF" or
"AUTO" position. The welcome light func-
tion will operate only when it is dark outside
the vehicle.
NOTE
l While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK switch on the remote
control transmitter.
NOTE
• Turn the combination headlamps and dip-
per switch to the " " or " " position.
• Put the operation mode of the power
switch in ON.
l It is possible to modify functions as follows:
• The headlamps can be set to come on in
the low beam setting.
• The welcome light function can be deacti-
vated.
For further information, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
On vehicles equipped with the Smartphone
Link Display Audio or the MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the
adjustment. Refer to the separate owner's
manual for details.
Coming home light
E00529001826
This function turns on the headlamps in the
low beam setting for about 30 seconds after
the operation mode is put in OFF.
1. Turn the combination headlamps and
dipper switch to the "OFF" or "AUTO"
position.
2. Put the operation mode of the power
switch in OFF.
OGGE19E1
Combination headlamps and dipper switch
3. Within 60 seconds of putting the opera-
tion mode in OFF, pull the turn signal
lever towards you.
4. The headlamps will come on in the low
beam setting for about 30 seconds. After
the headlamps go off, the headlamps can
be turned on again in the low beam set-
ting for about 30 seconds by pulling the
turn signal lever towards you within 60
seconds of putting the operation mode in
OFF.
To turn on the headlamps again after 60
seconds of putting the operation mode in
OFF, repeat the process from step 1.
NOTE
l While the coming home light function is op-
erating, perform one of the following opera-
tions to cancel the function.
Instruments and controls
6
6-65