Mitsubishi Outlander PHEV 2019 Manual page 288

At the point where the vehicle speed is raised
to your desired speed, push down and release
the "SET -" switch; the new speed is then set
in the system.
CAUTION
l The ACC braking control and proximity
alarm functions will not work while the ac-
celerator pedal is depressed.
NOTE
l The set speed indication on the display turns
to "---" when the accelerator pedal is de-
pressed. This indication remains as long as
the pedal is in a depressed position.
l The ACC control at the original set speed re-
sumes as soon as you release the accelerator
pedal. Under certain conditions, however,
the braking control and alarming functions
of ACC may not work for a short while after
releasing the accelerator pedal.
NOTE
l Set speed adjustment is impossible while the
accelerator pedal is in a depressed position.
To decrease the set speed
There are two ways to decrease the set speed.
By using the "SET -" switch:
The set speed decreases by 1 km/h (1 mph)
every time you push down the "SET -"
switch while the ACC control is working. If
you hold the switch pushed down, the set
speed decreases in increments of 5 km/h
(3 mph).
CAUTION
l The setting speed should be set up the suita-
ble speed according to a situation.
OGGE19E1
Adaptive Cruise Control System (ACC)*
NOTE
l There is some time lag between setting to a
new speed and actually decelerating to that
speed.
l If there is a vehicle in front and your vehicle
is following that vehicle at a speed lower
than the set speed, the set speed alone de-
creases with no actual deceleration taking
place.
l When the switch is held pushed, a buzzer
sounds every time the set speed changes.
By using the brake pedal:
If you depress the brake pedal while the ACC
control is working, the control is cancelled,
allowing you to decelerate the vehicle.
At the point where the vehicle slows down to
your desired speed, push down the "SET -"
switch; the new speed is then set in the sys-
tem.
Starting and driving
7
7-63