Reversing Sensor System - Mitsubishi ASX 2016 Owner's Manual

Reversing sensor system*

NOTE
l The reset function should be executed every
time when the tyre pressure or tyre rotation
is adjusted.
l The reset function should be executed when
the tyre is cold. If it is executed when the
tyre is warm (e.g. after driving), there may
be a low tyre pressure warning earlier than
usual.
6
Tyre ID set change
In case that 2 sets of tyre inflation pressure
sensor ID are registered in the receiver, the
valid tyre ID set can be changed by following
procedure.
1. Operate the multi-information meter
switch to switch the information screen
to the menu screen.
Refer to "Multi information display
switch" on page 5-05
Refer to "Changing the function settings
(when the ignition switch or the opera-
tion mode is ON)" on page 5-19
2. Lightly press the multi-information me-
ter switch to select "
ID set change).
6-64 Starting and driving
3. Press and hold the multi-information
meter switch for about 3 seconds or
more.
The setting changes the selected tyre ID
set.
Type 1
E00637600030
Type 2
NOTE
l Each time this procedure is done, the tyre ID
set is changed. (1 - 2 - 1 - 2 ...)
l
The tyre ID set is NOT changed, in case that
" (tyre
only 1 set of ID is registered.
OGAE15E5
NOTE
l When changing the tyre ID set, the reset
function of low tyre pressure warning
threshold is automatically started. (The
warning lamp start flashing slowly.) If the
tyre is warm at this time. the reset function
should be executed again when the tyre is
cold.
Reversing sensor system*
This system operates when you are backing
the vehicle. It uses corner and back sensors to
detect an obstacle and the information screen
in the multi-information display and the buz-
zer to inform you of the approximate distance
to the obstacle.
CAUTION
l The reversing sensor system assists you in
determining the approximate distance be-
tween the vehicle and an obstacle located
behind the vehicle. It has limitations in terms
of detectable areas and objects, and may not
properly detect some objects. Therefore, do
not place excessive confidence in the revers-
ing sensor system and operate the vehicle as
carefully as you would do with a vehicle not
equipped with this system.
E00615500345