Mitsubishi Outlander PHEV 2019 Manual page 449

How to change a tyre
WARNING
l Mount the wheel with the valve stem (I)
facing outboard. If you cannot see the
valve stem (I), you have installed the
wheel backwards.
Operating the vehicle with the wheel in-
stalled backwards can cause vehicle dam-
age and result in an accident.
9
7. Turn the wheel nuts clockwise by hand
to initially tighten them.
Temporarily tighten the wheel nuts by
hand until the flange parts of the wheel
9-16 For emergencies
nuts make light contact with the wheel
and the wheel is not loose.
CAUTION
l Never apply oil to either the wheel bolts or
the nuts, or they will tighten too much.
8. Lower the vehicle slowly by rotating the
wheel nut wrench anticlockwise until the
tyre touches the ground.
OGGE19E1
9. Tighten the nuts in the order shown in
the illustration until each nut has been
tightened to the torque listed here.
Tightening torque: 88 to 108 N•m
CAUTION
l
Never use your foot or a pipe extension for
extra force in the wheel nut wrench. If you
do so, you will tighten the nut too much.
10. Lower and remove the jack, then store
the jack, flat tyre, and chocks. Have your
damaged tyre repaired as soon as possi-
ble.
11. Check your tyre inflation pressure at the
next gasstation. The correct tyre pres-