Mitsubishi Outlander PHEV 2019 Manual page 64

NOTE
• When a microwave oven or ISM (indus-
trial, scientific and medical) equipment is
being used, the communication speed and
range of wireless LAN devices may de-
crease. Use your wireless LAN device
away from these appliances and equip-
ment.
• If a wireless LAN device and Bluetooth
(registered trademark of Bluetooth SIG,
Inc.) are used simultaneously, the commu-
nication speed and range of each device
may decrease. Use your wireless LAN de-
vice away from Bluetooth devices.
l Wireless LAN devices may not communi-
cate with the vehicle, or may not operate
normally or stably in the following environ-
ment or situations. Check that the device can
communicate with your vehicle before use.
• There is an obstruction such as a concrete
or metal wall between the vehicle and
wireless LAN device.
• The vehicle is surrounded by tall vehicles
in a parking lot.
• There are facilities nearby that emit strong
radio waves, such as a TV tower, trans-
former substation, broadcasting station or
airport.
• There is a communication device such as
a mobile phone or radio, or an electric de-
vice such as a personal computer near the
wireless LAN device.
• The wireless LAN device is in contact
with or covered by a metal object.
NOTE
• The battery of the wireless LAN device
has run down.
l The MITSUBISHI Remote Control cannot
be used under the following conditions:
• The wireless LAN device is turned off.
• The MITSUBISHI Remote Control appli-
cation software is not installed.
• The MITSUBISHI Remote Control appli-
cation software is not running.
• The wireless LAN device is not registered
on the vehicle or it is not connected to the
vehicle.
• The wireless LAN device is out of the
communication range.
• The wireless LAN device is connected to
other wireless LAN device.
• The wireless LAN device has failed, or its
battery has run out.
l Some charging facilities have a timer func-
tion that turns the power on or off at a spe-
cific time of the day. When charging at a fa-
cility with a timer function, make sure that
the charging timer is set within the time peri-
od when the power in the charging facility is
on.
l
The auxiliary battery is automatically and
periodically charged using electrical power
stored in the drive battery. A buzzer sounds
in the cabin while the auxiliary battery is be-
ing charged.
l While the remote climate control is operat-
ing or the charging, the cooling fan or air
conditioner compressor may start operating
and its sound may be heard. This is normal.
OGGE19E1
MITSUBISHI Remote Control*
NOTE
l The remote climate control operates in its
own mode based on the mode selected on
the wireless LAN device, regardless of the
switch setting of the vehicle's air condition-
er.
l Air conditioning performance may deterio-
rate or the remaining charge in the drive bat-
tery may decrease under the following con-
ditions:
• In extremely hot weather.
• In hot sunshine.
• In extremely cold weather.
l
If the remote climate control is started dur-
ing charging, the time until full charge may
extend or the charging rate may decrease.
l When the remaining quantity of the drive
battery is decreased, the remote climate con-
trol does not operate or it may stop on the
way.
l When the auxiliary battery is removed, the
timer control of the MITSUBISHI Remote
Control is reset and each function of the
MITSUBISHI Remote Control cannot be
used. Also the drive battery cannot be
warmed up.
Communicate the wireless LAN device and
your vehicle again.
Charging 3-23
3