Mitsubishi Outlander PHEV 2019 Manual page 168

5. If you hold down the multi information
display switch for about 2 seconds or
more, the setting is changed to the selec-
ted language.
NOTE
l If "---" is selected in the language setting, a
warning message is not displayed when
there is a warning display or interrupt dis-
play.
Changing the language cooper-
ative control
E00523301827
The language used in MITSUBISHI Multi-
Communication System (MMCS) (if so
®
equipped), Bluetooth 2.0 interface (if so
equipped) or Multi Around Monitor (if so
equipped) can be changed automatically to
the same language as that shown in the multi
information display.
1. Press and hold the multi information dis-
play switch for about 2 seconds or more
to switch from the setting mode screen
to the menu screen.
Refer to "Changing the function set-
tings" on page 6-17.
2. Lightly press the multi information dis-
play switch to select
(language cooperative control).
3. Press and hold the multi information dis-
play switch to switch from A/1 (lan-
guage cooperation enabled) to M/2/P
(language cooperation disabled), or from
M/2/P to A/1.
The setting is changed to the selected
condition.
NOTE
l The language display modified with the lan-
guage setting can be switched in the follow-
ing manner.
• When A or 1 has been selected with the
language cooperative control, the lan-
guage for MITSUBISHI Multi-Communi-
cation System (MMCS), Bluetooth
interface or Multi Around Monitor is au-
tomatically changed to the language se-
lected for the multi information display.
However, this changing function may not
work depending on the language selected
for the multi information display.
• When M, 2 or P has been selected with
the language cooperative control, the lan-
guage for MITSUBISHI Multi-Communi-
cation System (MMCS), Bluetooth
interface or Multi Around Monitor is not
automatically changed to the language se-
lected for the multi information display.
l The language on the display of the audio
system (if so equipped) is not automatically
" "
changed even if you select A or 1 of the lan-
guage cooperation control.
OGGE19E1
Multi information display
Operation sound setting
You can turn off the operation sounds of the
multi information display switch and rheostat
illumination button.
1. Press and hold the multi information dis-
play switch for about 2 seconds or more
to switch from the setting mode screen
to the menu screen.
Refer to "Changing function settings" on
page 6-17.
2. Lightly press the multi information dis-
play switch to select " " (operation
sound setting).
3. Press and hold the multi information dis-
play switch for about 2 seconds or more
®
2.0
to switch from ON (operation sound on)
to OFF (operation sound off), or from
OFF to ON.
The setting is changed to the selected
condition.
NOTE
l
The operation sound setting only deactivates
®
2.0
the operation sound of the multi information
display switch and rheostat illumination but-
ton. The warning display and other sounds
cannot be deactivated.
Instruments and controls
E00523400690
6
6-21