Mitsubishi Outlander PHEV 2019 Manual page 444

12. After injecting the sealant, securely fit
the valve remover (E) into the end of the
filler hose (J) to prevent sealant from
leaking from the empty bottle.
13. Pull out the compressor hose (K) from
the side of the tyre compressor, and then
securely attach the hose to the tyre valve
(D).
14. Place the compressor (L) with its air
pressure gauge (M) on top.
Pull out the compressor's power cord
(N), insert the plug on the cord into the
accessory socket (O), and then put the
operation mode of the power switch in
ACC. (Refer to "Accessory socket*" on
page 8-75.)
Turn ON the compressor switch (P) and
inflate the tyre to the specified pressure.
(Refer to "Tyre inflation pressures" on
page 11-10.)
OGGE19E1
Tyre repair kit
CAUTION
l The supplied compressor is designed only
for inflation of your vehicle tyres.
l The compressor is designed to run on a vehi-
cle's 12 V power supply. Do not connect it
to any other power source.
l The compressor is not waterproof. If you use
it in rain, make sure water does not get on it.
l
Any sand or dust sucked into the compressor
could make the compressor break down. Do
not place the compressor directly on any
sandy or dusty surface when using it.
l Do not disassemble or modify the compres-
sor. Also, do not subject the air pressure
gauge to shock. It could malfunction.
15. Check and adjust the tyre pressure with
reference to the air pressure gauge on the
compressor. If you overinflate the tyre,
release air by loosening the hose's end
fitting.
If there is a gap between the tyre and
wheel because the tyre has moved in-
ward from the wheel rim, press the pe-
riphery of the tyre towards the wheel to
close the gap before running the com-
pressor. (With no gaps, the tyre pressure
will rise.)
CAUTION
l Be careful not to get your fingers trapped be-
tween the tyre and wheel as the tyre inflates.
For emergencies
9
9-11